Scantech Vega V-1010 Uživatelský manuál Strana 22

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 121
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 21
18 Configuring the VEGA
ATTENTION
The VEGA scanner must be charged for a minimum of 8 hours
before the scanner can be placed in full operation for the first
time.
The cradle red led will indicate in red when the scanner is
charged.
After the battery is full, The charge green light will be light.The
charge green light will be off when the scanner leaving from
cradle.
If the battery power of the VEGA is too low, the VEGA will
indicate this with red led and beeper warning.
It is important to know that the VEGA scanner will only communicate with the
cradle whose unique Bluetooth MAC address was the last address scanned.
If a cradle is paired with the VEGA scanner, another VEGA scanner can’t be
paired with that cradle until the original connection is broken.
If you pair a second VEGA scanner to an in use cradle, the cradle’s
connection to the first VEGA scanner will be broken and the connection re-
established with the second VEGA scanner.
4.3.3 Set up Server Mode Communication
To set-up the communication between the VEGA scanner and Bluetooth
application device follow the next steps.
1. The VEGA scanner must scan “Scanner Server Mode ON/Scanner
Client Mode Off” barcode, to set the VEGA scanner in server mode.
BT MAC
Address
Zobrazit stránku 21
1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 120 121

Komentáře k této Příručce

Žádné komentáře